Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • AvatarJerry R
    Post count: 1

    I’m working on Lesson 20 and 4:57 where it says to “create a selection with the Powell and ending with the last Mitch interview” Once I have my selection, I switch to the Position tool. When I place the Position tool inside one of the selected clips and drag to the right, a symbol appears below the Position tool. The symbol is a circle with a diagonal line through it.

    If I select a single clip I am able to reposition just fine. The problem seems to lie with the Mitch-3A clip which has the Powel and Crater clips attached to it. If I select those 3 clips and try to move with the Position tool, I get the same circular symbol with the diagonal line through it.

    Any input on what I am doing incorrectly is greatly appreciated.

     

    Jerry R

    Travis RichmondTravis Richmond
    • Ripple Staff
    Post count: 14

    Make sure you are clicking and dragging the clip in the primary storyline. If you try to do it by clicking and dragging on the connected clips it will not work.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.